Transmission Housing

Special tools and workshop equipment required 

• Holding FixtureVW 801
• Locking Pin30-505
• Thrust Pad3124
• Subframe Support Assem. Device3290
• DriftT10168
• Torque Wrench (5-50 Nm)V.A.G 1331
• Kukko Extractor 18.5-23.5 mm21/3
• Threaded Adapter from Kukko Support22/1
• Kukko Support22/2
• Kukko Extractor 14.5-18.5 mm21/2
• Sealing PasteAMV 188 200 03

Fig 1: Identifying Selector Shaft Bushing, Removal

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Use the threaded adapter -arrow- from the Kukko support22/1.

-- Hold the spindle on the subframe support assem. device3290 and turn the nut -B-.

A - Extractor 14.5-18.5 mm, for example 21/2.

Fig 2: Driving Bearing Bushing For Selector Shaft In To Tool Stop

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Fig 3: Remove the Gearshift Rod Bearing Bushing -C-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

A - Support, for example 22/2.

B - Extractor 18.5-23.5 mm, for example 21/3

Fig 4: Installing Selector Rod Bushing

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.