Brake System (Complete): Remove & Replace
WARNING: This page is about the Touareg Hybrid, which is a different variant/trim than selected.
Includes: Replace Calipers and/or Wheel Cylinders, Brake Shoes and/or Pads. Clean, lube and/or replace Brake Hardware as necessary. Inspect Master Cylinder, all Hoses and bleed Brake System. Adjust Brakes (where applicable).
Includes: Repack Wheel Bearings (where applicable).
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| All Wheels | Includes: Additional time for use of scan tool to perform this procedure. | 4.0 | B | |
| Combination Procedure: BRAKE HOSE: Replace: | ||||
| Each | 0.2 | B | ||
| Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle: | ||||
| 0.5 | B | |||
| Combination Procedure: DISC ROTOR: Remove and Install for Refinishing: | ||||
| Each | 0.1 | B | ||
| Combination Procedure: DISC ROTOR: Replace: | ||||
| Each | 0.1 | B | ||
| Combination Procedure: WHEEL BEARING: Replace: | ||||
| Front,One Side,Bolt-On | 0.8 | B | ||
| Front,One Side,Press Fit | 1.4 | B | ||
| Rear,One Side | 2.2 | B | ||