Safety Precautions And Conditions For Removing And Installing Tires And Wheels With Run-Flat Tires
- Work for removing and mounting tires with emergency running characteristics must only be performed by technicians specially trained for it.
- The special tools necessary must be in proper working order and not damaged! Contact the manufacturer of tire mounting device found in the shop directly for suitable additional tools. Additional tools are offered as recommended accessories for the tire mounting devices listed with VAS - numbers.
- If necessary, use a mounting paste recommended by the tire manufacturer.
- The description of work procedure for removing and mounting may vary depending on the device manufacturer and type of device.
- The following work procedure described explains the principal procedure for removing and mounting tires with emergency running characteristics. It is important to recognize run-flat tires before starting the removal and mounting process as it will be different from the process used with standard tires.
- Characteristics: these tires are identified with the following abbreviations: DSST, Euforia, RFT, ROF, RSC, SSR or ZP. These abbreviations are located on the sidewall behind tire designation of the respective tire manufacturer.
- Always note the instructions and danger warnings identified in the following description!
NOTE:
During removal and mounting work, make sure that no contact is made between tires and Tire Pressure Monitoring Sensor --.
When cleaning disc wheel (rim), tire pressure monitor sensor must not come into contact with water or be blown with pressurized air.