Left Rear Level Control System Sensor -G76-

Special tools and workshop equipment required 

• Torque Wrench 2-10 Nm VAG1783

Removing 

-- Disconnect the harness connector -1-.

Fig 1: Identifying Harness Connector And Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -2- from the lower transverse link.

-- Remove bolts -arrows- from the subframe.

-- Remove Left Rear Level Control System Sensor -G76-.

Installing 

Installation is the reverse of removal, with special attention to the following:

The Left Rear Level Control System Sensor -G76- lever must point toward the outside of the vehicle.

-- Perform a basic setting on the headlamps after replacing them. Refer to Vehicle Diagnostic Tester.

Tightening Specifications