Vibration Damper Seal, Replacing: Installing

WARNING: This page is about a different car, the 2013 Volkswagen Jetta and 2012 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specifications, refer to RIBBED BELT OVERVIEW .

-- Clean the running and sealing surface.

-- Remove the Sleeve T10368.

Fig 1: Identifying Special Tool T10368

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pull the seal -arrow- in using the thrust piece T10354 and the vibration damper bolt in all the way.

Fig 2: Identifying Thrust Piece T10354

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Replace the vibration damper bolt and an O-ring -1-.

Fig 3: Identifying O-Ring And Tooth Contour

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Further installation is in the reverse order of removal.