Camshaft Timing Chain Overview
WARNING: This page is about a different car, the 2013 Volkswagen Jetta and 2012 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 9 Nm
- Chain Tensioner
- Is under tension.
- Secure it using the locking pin T40011 before removing.
- Timing Chain Tensioning Rail
- Guide Pin
- 20 Nm
- Bolt
- 9 Nm
- Control Valve
- 35 Nm
- Has left hand threads.
- Remove using the assembly tool T10352.
- Bolt
- Removing and installing:
M6 bolt:
- 8 Nm + 90° (1/4) additional turn.
M8 bolt:
- 20 Nm + 90° (1/4) additional turn.
- Removing and installing:
- Washer
- Bearing Bracket
- Camshaft Timing Chain Guide Rail
- Camshaft Housing
- Camshaft Timing Chain
- Before removing, mark the direction of rotation with paint.
- Removing and installing, refer to CAMSHAFT TIMING CHAIN .
- Camshaft Timing Chain Guide Rail
- Guide Pin
- 20 Nm
- Crankshaft Sprocket
- Note the installed position, refer to Fig 2.
- Both surfaces -arrows- must line up across from each other.