Coolant Pipes Overview

WARNING: This page is about a different car, the 2013 Volkswagen Jetta and 2012 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Install only approved clamps for securing hose connections.

The arrows on the coolant pipes and ends of the coolant hoses must align when installing.

Coolant hose connection diagram. Refer to one of the following:

With a manual transmission , refer to COOLANT HOSE CONNECTION DIAGRAM .
With a Direct Shift Gearbox (DGS) , refer to COOLANT HOSE CONNECTION DIAGRAM .

Fig 1: Identifying Coolant Pipes Assembly And Overview

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Front Coolant Pipes
- Removing and installing, refer to FRONT COOLANT PIPES .
Coolant Hose
- From the turbocharger.
Coolant Hose
- To the coolant expansion tank.
Bolt
- 5 Nm
O-ring
- Always replace.
Coolant Hose
- To the heater core.
Small Coolant Pipe
- Removing and installing, refer to SMALL COOLANT PIPE .
Bolt
- 9 Nm
Coolant Hose
Bolt
- 5 Nm
Coolant Hose
- From the After-Run Coolant Pump -V51-.
Coolant Hose
- To the after-run coolant pump.