Overview - SUBFRAME Mount

Tightening Specifications

NOTE:

The subframe mount bolts have reduced shanks. They must be replaced.

Subframe Mount, Engine

Fig 1: Identifying Engine Mount & Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

A ¹⁾ = 20 Nm +90° turn

B ¹⁾ = 40 Nm +90° turn

C ¹⁾ = 60 Nm +90° turn

¹⁾ Replace after removing

Subframe Mount, Transmission

Fig 2: Identifying Transmission Mount & Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

A ¹⁾ = 40 Nm +90° turn

B ¹⁾ = 60 Nm +90° turn

¹⁾ Replace after removing

Pendulum Support

Fig 3: Identifying Pendulum Supports & Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

A ¹⁾ = 40 Nm +90° turn

B ¹⁾ = 100 Nm +90° turn

¹⁾ Replace after removing

Removing the pendulum support: Remove the bolt -B- first and then the bolts -A-.

Installing the pendulum support: First tighten the bolts -A- and then bolt -B-.