LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2011 >> Jetta Base >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Exterior Body Panels (Hood, Lids) (Sedan) >> (55 Hood, Lids) >> Description And Operation >> Rear Lid Seal

Rear Lid Seal

The seal on the rear lid is equipped at the factory with a sealant, applied to body flange and then rolled on.

NOTE:

When the seal is removed, the sealant spreads on the inner side of the seal and the sides bend up slightly. If the seal is being installed again, the sealing performance and proper seating are no longer guaranteed.

For this reason, every seal, that has been removed completely, must be replaced with a "hammer-stroke seal".

For partially removed seals, seal flanks must be pressed together before installation.

scientia non olet · About LEMON Manuals