Vacuum Diaphragm Overview

NOTE:

Secure all hose connections using hose clamps appropriate for the model type.

Hose connections and charge air system hoses must be free of oil and grease before installing. For connector couplings, the seal and sealing surfaces must only be lightly oiled. Refer to CHARGE AIR HOSE, DISCONNECTING AND CONNECTING .

The charge air system must be properly sealed.

Replace the self-locking nuts.

Hose clip pliers VAS 6362 or V.A.G 1921 are recommended for installing spring clamps.

Add oil to the turbocharger through the oil supply pipe connection to the turbocharger

After installing the turbocharger, let the engine idle for approximately 1 minute without increasing the engine speed. This ensures adequate oil supply to the turbocharger.

Pay attention to the rules of cleanliness. Refer to CLEAN WORKING CONDITIONS .

NOTE:

Engine codes CCTA and CBFA do not have an adjustable vacuum diaphragm.

Fig 1: Identifying Assembly Overview: Turbocharger - Part IV

Courtesy of AUDI OF AMERICA, LLC

Turbocharger
- Can only be replaced with the exhaust manifold and vacuum diaphragm.
- Removing and installing, refer to TURBOCHARGER .
Vacuum Diaphragm
- Checking, refer to TURBOCHARGER VACUUM DIAPHRAGM, CHECKING .
- Removing and installing, refer to TURBOCHARGER VACUUM DIAPHRAGM .
Bolt
- 10 Nm
Nut
- 9 Nm
- Secure with sealing wax
- Not available with engine codes CCTA and CBFA.
Securing Plate
- Not available with engine codes CCTA and CBFA.
Knurled Nut
- Not available with engine codes CCTA and CBFA.