Special Tools
Special tools and workshop equipment required
- Diagnostic Cable, 3 m with Power Supply VAS 5051/1
- or Diagnostic Cable, 5 m without Power Supply VAS 5051/3
- Plate from Puller T10037
- Thrust Piece T10049
- Drip Tray for VAS 6100 VAS 6208
- Torque Wrench (5-50 Nm) V.A.G 1331
- Torque Wrench (40-200 Nm) V.A.G 1332
- Counterhold Tool T10172
- Vehicle Diagnosis and Service Information System VAS 5052
- or Vehicle Diagnosis, Testing, and Information System VAS 5051
- Charging Device F/Haldex 2 Coup. VAS 6291
- Vehicle Diagnosis and Service System VAS 5052
- Tensioning Strap T10038
- Engine-/Gearbox Jack V.A.G 1383 A
- Torque Wrench V.A.G 1783
- Drip Tray for VAS 6100 VAS 6208
Fig 11: Identifying Special Tools -- Rear Final Drive Flange/Drive Shaft Seal, Final Drive Installed, Replacing
Special tools and workshop equipment required
- Extractor Lever VW 681
- Drive Sleeve 30-20
- Counter Support 3415
- Thrust Piece T10019
- Kukko Puller No. 12/1 100 x 100 mm Kukko 12/1
- Torque Wrench V.A.G 1601
Special tools and workshop equipment required
- Thrust Piece 3291/1 from the Assembly Device 3291
- Spindle from the Assembly Device 3292
- Thrust Pieces 3348 and 3348/1 from the Front and Rear Bearing Tool 3348
- -1- Kukko Extractor 46-58 mm 21/7
- -4- Kukko Support Kukko 22/2