Vehicle Diagnostic Tester, Connecting And Function Selecting
Special tools and workshop equipment required
- Vehicle Diagnosis, Testing and Information System VAS 5051
- or Vehicle Diagnosis and Service Information System VAS 5052
- Diagnostic Cable, 3 m with Power Supply VAS 5051/1
- or Diagnostic Cable, 5 m without Power Supply VAS 5051/3
Measurement and testing procedures should be performed as follow to avoid the risk of an accident:
- Only the vehicle diagnostic tester VAS 5051 A or VAS 5052 may be used to read out measured value blocks. The device must always be secured on the rear seat and operated from there by a second person.
-- Turn off the ignition and connect the vehicle diagnostic tester -1- to the diagnostic connection using the diagnostic lead VAS 5051/1 or VAS 5051/3 -2-.
Installed location: Left front foot well.
-- Turn on the tester -arrow-.
The tester is ready to be used when it displays a picture (photograph) of a vehicle.
Starting "Guided Fault Finding" :
-- Turn on the ignition.
-- Press the "Guided Fault Finding" button on the screen.
-- Then select the following one after the other:
- Brand
- Type
- Model year
- Version
- Engine code
-- Confirm the entered data.
Wait for the tester to check all the control modules in the vehicle.
-- Press GO TO and then select "function/component selection".
Follow the displays on the screen to start the desired functions.