LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2009 >> Tiguan SE 4Motion >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Exterior Body Panels (Hood, Lids) >> (55 Hood, Lids) >> Description And Operation >> Rear Lid >> Rear Lid Seal

Rear Lid Seal

The seal on the rear lid is equipped at the factory with a sealant, applied to body flange and then rolled on.

NOTE:

The sealing compound will be distributed on the inside of the seal and the flanks will be slightly bent when the seal is removed. When the seal is installed again, it may not fit securely and it make leak.

For this reason, every completely removed seal must be replaced with a so-called "hammer-stroke seal".

For partially removed seals, seal flanks must be pressed together before installation.

scientia non olet · About LEMON Manuals