Structure-Borne Sound Actuator -R214- AND Structure-Borne Sound Control Module -J869- OVERVIEW

WARNING: This page is about a different car, the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2009 Volkswagen GLI, 2008 Volkswagen Jetta, and 2008 Volkswagen GLI. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The structure-borne sound actuator and structure-borne sound control module are not installed in all vehicles.

The plenum chamber cover and bulkhead must be removed to remove and install. Refer to Description and Operation .

Fig 1: Identifying Assembly Overview: Structure-Borne Sound Actuator -R214- And Structure-Borne Sound Control Module -J869-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Structure-Borne Sound Control Module
- Installed location: In the plenum chamber.
- Remove the plenum chamber cover and bulkhead to remove and install.
Bolt
- 8 Nm
Nut
- 8 Nm
Structure-Borne Sound Actuator Bracket
Nut
- 15 Nm
Bolt
- 8 Nm
Bolt
- 8 Nm
Structure-Borne Sound Actuator
- Installed location: In the plenum chamber.
- Remove the plenum chamber cover and bulkhead to remove and install.
Structure-Borne Sound Control Module Bracket
Nut
- 8 Nm