General Repair Information

WARNING: This page is about a different car, the 2008 Volkswagen Jetta, 2008 Volkswagen GLI, 2007 Volkswagen Jetta, and 2006 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

If large quantities of metal particles or abraded material are detected during engine repairs, it may be an indication of a damaged crankshaft or rod bearings. To prevent further damage, perform the following steps after the repair:

Carefully clean the oil passages.

Replace the oil injection jets.

Replace the oil cooler.

Replace the oil filter.

WARNING:

Due to the factory coating on the cylinder walls, it is imperative the cylinders are NOT honed during any repair!

NOTE:

Repairs on the clutch. Refer to [For transmission(s) 02Q] Removal and Installation .

NOTE:

Before removing the crankshaft, prepare for appropriate storage so that sensor wheel does not make contact or become damaged.

The engine is to be secured to the engine and transmission holder VAS 6095 for performing assembly work.