LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2009 >> GLI 2.0 J, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Controls, Housing - Automatic Transmission 02E (Sedan) (A5 Platform)) >> 34 Controls, Housing >> Diagnosis And Testing >> Selector Lever Cable, Checking

Selector Lever Cable, Checking

WARNING: This page is about a different variant/trim than selected.

Short Description 

The selector lever cable must be disconnected from the transmission in order to check it for ease of movement. Do not let the removed end touch anything.

Then, the selector lever is moved and installed again on the transmission.

After that, the selector lever cable must be adjusted. Refer to SELECTOR LEVER CABLE, ADJUSTING .

Do not lubricate the cable connections.

Checking 

-- Move the selector lever into the "P" position.

-- Remove the cable from the lever on the transmission.

-- Move the selector lever from "P" to "S" and back to "P" several times.

-- Install the cable with new lock washers and a loosened adjustment bolt.

-- Adjust the cable. Refer to SELECTOR LEVER CABLE, ADJUSTING .

scientia non olet · About LEMON Manuals