Engine And Transmission Mount Tightening Specifications

WARNING: This page is about a different car, the 2006 Volkswagen Jetta and 2005 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Engine Mount & Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

A = 20 Nm + 90° (¹ /₄ additional rotation) - replace the bolts

B = 40 Nm + 90° (¹ /₄ additional rotation) - replace the bolts

C = 60 Nm + 90° (¹ /₄ additional rotation) - replace the bolts

Fig 2: Identifying Transmission Mount & Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

A = 40 Nm + 90° (¹ /₄ additional rotation) - replace the bolts

B = 60 Nm + 90° (¹ /₄ additional rotation) - replace the bolts

Fig 3: Identifying Pendulum Supports & Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

A Strength class 8.8 = 40 Nm + 90° (¹ /₄ additional rotation) - replace the bolts

A Strength class 10.9 = 50 Nm + 90° (¹ /₄ additional rotation) - replace the bolts

B = 100 Nm + 90° (¹ /₄ additional rotation) - replace the bolt

Removing: First remove bolt -B-, then bolts -A-.

Installing: First install bolts -A-, then bolt -B-.