Fastener Tightening Specifications

WARNING: This page is about a different car, the 2006 Volkswagen Jetta and 2005 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Components

Bolt Size

Dual Mass Flywheel to Crankshaft Bolt ⁽¹⁾

60 + 90° turn

Engine Mount to Engine Support Bolt

60 + 90° turn

Sealing Flange Bolt

⁽¹⁾	Always replace

Engine Mount Bracket to Cylinder Block Bolt Tightening Sequence

Fig 1: Identifying Engine Mount Bracket To Cylinder Block Bolt Tightening Sequence

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

I : Underhood engine mount bracket, from 06.05

II: Under floor engine mount bracket, through 05.05

Tighten the engine mount bracket bolts in the sequence -1 through 3- shown to 40 Nm + 180° (¹ /₂ turn) additional turn.