Fastener Tightening Specifications
WARNING: This page is about a different car, the 2010 Volkswagen Jetta and 2009 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
| Component | Fastener Size | Nm | ||||||
|---|---|---|---|---|---|---|---|---|
| Connection to Oil Filter Bracket | - | 30 | ||||||
| Cover to Oil Filter Bracket | - | 25 | ||||||
| Oil Cooler to Oil Filter Bracket Locking Bolt | - | 25 | ||||||
| Oil Filter Bracket to Cylinder Block Bolt 1, 3 | - | 15 + 90° | ||||||
| Oil Pressure Switch to Oil Filter Bracket | - | 22 | ||||||
| Oil Supply Line Clamp Bolt | - | 10 | ||||||
| Oil Supply Line to Connection | - | 22 | ||||||
| Wiring Harness Bracket to Oil Filter Bracket Bolt | - | 10 | ||||||
| Engine Code CBEA | ||||||||
| Balance Shaft Spur Gear to Balance Shaft Bolt (1) | - | 20 + 90° | ||||||
| Intake Tube to Oil Pump Bolt | - | 10 | ||||||
| Intermediate Sprocket/Hub to Balance Shaft Module Bolt 1 | - | 90 + 90° | ||||||
| Oil Pan to Cylinder Block Bolt (2) | ||||||||
| - | 15 | |||||||
| - | 40 | |||||||
| Oil Pan Drain Plug | - | 30 | ||||||
| Oil Pan to Transmission Bolt | - | 45 | ||||||
| Oil Pump to Balance Shaft Module Bolt | - | 10 | ||||||
| Oil Spray Jet to Cylinder Block Bolt | - | 27 | ||||||
| Oil Suction Pipe to Balance Shaft Module Bolt | - | 10 | ||||||
| Engine Code CJAA | ||||||||
| Chain Tensioner with Tensioning Rail to Cylinder Block Bolt | - | 15 | ||||||
| Oil Level Thermal Sensor to Oil Pan Bolt | - | 10 | ||||||
| Oil Pan to Cylinder Block Bolt | - | 15 | ||||||
| Oil Pan Drain Plug (1) | - | 30 | ||||||
| Oil Pan to Transmission Bolt | - | 40 | ||||||
| Oil Pump Sprocket to Oil Pump Bolt | - | 20 + 90° | ||||||
| Oil Spray Jet to Cylinder Block Bolt | - | 27 | ||||||
| Sealing Flange to Cylinder Block Bolt | - | 15 | ||||||
| Splash Wall to Cylinder Block Bolt | - | 15 | ||||||
| Suction Line to Oil Pump Bolt | - | 15 | ||||||
|
||||||||
Balance Shaft Module Bolt Tightening Sequence and Specification, Engine Code CBEA Only
-- Install the new bolts in sequence -1 through 8- and tighten them by hand.
-- Tighten the balance shaft module bolts as follows:
-- Tighten the bolts in sequence -1 through 8- to 6 Nm.
-- Tight the bolts -5 and 7- to 13 Nm.
-- Tighten the bolts -5 and 7- an additional 90° (1/4) turn using a ratchet.
-- Tighten the bolts -1 through 4, 6 and 8- to 20 Nm.
-- Tighten to bolts -1 through 4, 6 and 8- an additional 90° (1/4) turn using a ratchet.