Engine Pre-Warmer

WARNING: This page is about a different car, the 2010 Volkswagen Jetta and 2009 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Refractometer T10007
Drip Tray for VAS 6100 VAS 6208
Torque Wrench (5-50 Nm) V.A.G 1331
Hose Clip Pliers VAS 6362

Removing

-- Remove the noise insulation. Refer to Description and Operation .

-- Drain the coolant. Refer to DRAINING AND FILLING .

-- Loosen the coolant hose clamp and remove the coolant hose from the connection -arrow A-.

Fig 1: Identifying Coolant Hose Clamp, Coolant Hose And Engine Pre-Warmer With Connector

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Unclip the retainer and disconnect the engine pre-warmer connector -arrow D-.

-- Loosen the coolant hose clamp and remove the coolant hose from the connection -arrow E-.

-- Release the clamp -arrow B- and remove the engine pre-warmer -arrow C- downward.

Installing

Install in reverse order of removal.

-- Fill with coolant. Refer to DRAINING AND FILLING .

-- Install the noise insulation. Refer to Description and Operation .