LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2009 >> GLI 2.0 J, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 207 (2.0L - Cooling System - Engine Code(S): CBEA & CJAA (Sedan) (A5 Platform)) >> 19 Cooling System >> General Information >> Cooling System Components

Cooling System Components

WARNING: This page is about a different car, the 2010 Volkswagen Jetta and 2009 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

Risk of scalding due to hot steam and hot coolant:

  • When the engine is warm the coolant system is under pressure.
  • Wear protective goggles and protective clothing to prevent damage to eyes and scalding.
  • Reduce pressure by covering the coolant expansion tank cap with a cloth and carefully opening.
WARNING:

When doing any repair work, especially in the engine compartment, pay attention to the following due to clearance issues:

  • Route all lines and wires in their original locations.
  • For example, for fuel, hydraulic, Evaporative Emission (EVAP), coolant, refrigerant, brake fluid and vacuum lines.
  • Ensure sufficient clearance to all moving or hot components.
NOTE:

Secure all hose connections using hose clamps appropriate for the model type.

Hoses are secured with spring type clamps. In cases of repair only use spring type clamps.

Hose clip pliersVAS 6362 or VAS 6340 are recommended for installing spring clamps.

When installing coolant hoses, make sure they are free of stress and do not come into contact with other components (observe the marks on the coolant connections and hoses).

Special tools and workshop equipment required 

scientia non olet · About LEMON Manuals