Leak Detection Pump

WARNING: This page is about a different car, the 2008 Volkswagen Jetta, 2008 Volkswagen GLI, 2007 Volkswagen Jetta, and 2006 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Removing

-- Remove the right rear wheel housing liner. Refer to Removal and Installation .

-- Remove the connections -2 and 4-.

Fig 1: Identifying Leak Detection Pump (LDP) V144 Electrical Harness Connector

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the electrical connector -3-.

-- Remove the nuts -1-.

-- Remove the Leak Detection Pump (LDP) with bracket.

Installing

Installation is performed in the reverse order of removal. When doing this note the following:

Make sure the lines are connected securely.

-- Install the right rear wheel housing liner. Refer to Removal and Installation .

Tightening Specifications

Component		Nm
Leak Detection Pump (LDP) to body		6