EVAP Canister

WARNING: This page is about a different car, the 2008 Volkswagen Jetta, 2008 Volkswagen GLI, 2007 Volkswagen Jetta, and 2006 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Removing

-- Remove the cover bolts -arrows- and remove the cover -A-.

Fig 1: Identifying Cover Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the lines -1, 2 and 3-. To do so, press in or press together the securing ring.

Fig 2: Identifying Evaporative Emissions (EVAP) Canister Lines (Vehicles With Engine Code BGP)

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press the locking mechanisms on the bolt points in the -direction of the arrow- using a screwdriver and remove the EVAP canister -4-.

Installing

Installation is performed in the reverse order of removal. When doing this note the following:

Make sure the lines and EVAP canister are locked securely.

Tightening Specifications

Component		Nm
EVAP canister to body		8