Clamps And Exhaust Gas Temperature Sensor, Installed Position

WARNING: This page is about a different car, the 2010 Volkswagen Jetta and 2009 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Clamp Installed Position between the Particulate Filter and Turbocharger

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the new clamp so the bolt faces down and the -+/- 10°- angle is maintained.

Fig 2: Clamp Installed Position between the Particulate Filter and Exhaust Gas Recirculation (EGR) Filter

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the new clamp so the bolt faces down and the -+/- 10°- angle is maintained.

Fig 3: Exhaust Gas Temperature (EGT) Sensor Installed Position

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the EGT sensor so the angles are maintained:

Exhaust gas temperature sensor 3 -G495- -1- : angle -23°-.
Exhaust gas temperature sensor 2 -G448- -1- : angle -30°-.

Engine Code CJAA:

Fig 4: Installed Position of the Clamp between the Exhaust Door Control Unit and NOx Reduction Catalytic Converter

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the new clamp maintaining the -45° +/- 10°- angle.