Secondary Air Injection Pump Motor -V101-

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2008 Volkswagen Jetta, 2007 Volkswagen Jetta, and 2006 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Removing

-- Remove the noise insulation. Refer to Removal and Installation .

-- Disconnect the connectors -1 and 2-.

Fig 1: Identifying Connectors, Cable Guide Clip & Cable Clip

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press out the clip -3- for the wire guide.

-- Press out the wire clip at the top front bolt.

-- Disconnect the pressure tube -1- and vent tube -2-. To do so, compress the securing ring.

Fig 2: Identifying Pressure Hose And Intake Hose

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the nuts and remove the Secondary Air Injection (AIR) pump motor upward. When doing this, press the lower bolt (rubber bushing) slightly in order to get by the transmission.

Installing

Installation is performed in the reverse order of removal. When doing this note the following:

Make sure that the pressure and vent tubes lock securely to AIR pump motor.

Tightening Specifications

Component	Nm
Secondary air injection pump motor to intake manifold support	10