LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2009 >> GLI 2.0 J, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 182 (1.9L - Fuel Injection System - Engine Code(S): BKC, BLS, BRM & BXE (A5 Platform)) >> 23 Fuel Injection System >> Removal And Installation >> Automatic Glow Time Control Module

Automatic Glow Time Control Module

WARNING: This page is about a different car, the 2006 Volkswagen Jetta and 2005 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Removing 

-- Remove engine cover.

One Piece Engine Cover 

Fig 1: Identifying Removal Of One Piece Engine Cover
GWWN10-10000Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Pull the one piece front engine cover -arrows A- upward with a quick jerk and then pull the lower mount -arrow B- forward.

Two Piece Engine Cover 

Fig 2: Identifying Removal Of Two Piece Engine Cover
GWWN10-10221Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

On the two piece engine cover, first pull the outer cover upward with a quick jerk -arrows in the upper illustration-, then pull the inner engine cover upward with a quick jerk -arrows in lower illustration-.

-- Disconnect electrical harness connector -2- at Mass Air Flow (MAF) sensor -G70-.

Fig 3: Identifying Ventilation Hose -1-, Electrical Harness Connector -2-, Spring-Type Clip -3-, Bolt -4- And Intake Manifold -5-
GWWM10-0074Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the ventilation hose -1- and disengage it from the bracket -arrow-.

-- Open the spring-type clip -3- using spring-type clip pliers VAS 5024A and disconnect the intake hose from the Mass Air Flow (MAF) sensor -G70-.

-- Disconnect the intake manifold -5- from the air guide.

-- Unfasten bolt -4- and remove air filter housing and mass air flow sensor.

-- Remove battery, refer to [For transmission(s) 0A4, 02E, 09G, 02Q] Removal and Installation .

-- Remove battery holder bolts -arrows- and holder.

Fig 4: Identifying Battery Holder Bolts
GWWA10-1572Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pull out the 6-pin relay carrier under the engine compartment E-box in -direction of arrow-.

Fig 5: Identifying Direction To Pull Out 6-Pin Relay Carrier From Under Engine Compartment E-Box
GWWA97-0809Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Unclip the cover of the 6-pin relay carrier -arrows-.

Fig 6: Identifying Clips To Cover Of 6-Pin Relay Carrier
GWWA97-0810Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Release the retaining clips -arrows-.

Fig 7: Identifying Release Of Retaining Clips
GWWA97-0811Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the 6-pin relay carrier -arrow- from the cover.

Fig 8: Identifying 6-Pin Relay Carrier From Cover
GWWA97-0812Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pull the automatic glow time control module -J179- off from position -R2-.

Fig 9: Identifying Automatic Glow Time Control Module J179 In Position R2
GWWA97-1025Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Installing 

Installation is performed in reverse order. When doing this note the following:

-- Install battery, refer to [For transmission(s) 0A4, 02E, 09G, 02Q] Removal and Installation .