Selector Lever And Mechanism With Cable, From 03.2009

NOTE:

The selector mechanism and the selector lever cable cannot be separated from each other. Both are removed at the same time.

Fig 1: Identifying Selector Mechanism And Selector Lever Cable

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

After installation, the selector lever cable movement must be checked and adjusted.

Removing 

-- Move the selector lever into the "P" position.

-- Remove the selector lever handle. Refer to SELECTOR HANDLE .

-- Remove the center console. Refer to Removal and Installation .

-- Disconnect the connector from the selector mechanism.

-- Remove the 4 screws.

Fig 2: Identifying Removal Of Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Tightening specification: 8 Nm.

-- Disconnect the cable -arrows 1- and then remove it from the cable bracket -arrow 2-.

Fig 3: Identifying Cable Disengaged And Removed From Mounting Bracket

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pry the cable -1- off the lever -3- using a open end wrench -2-.

Fig 4: Identifying Selector Lever Cable, Lever/Selector Shaft And 10mm Open-End Wrench

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Lift the vehicle.

-- Remove the exhaust system components underneath the heat shield. Refer to Description and Operation .

-- Remove the heat shield under the selector mechanism.

-- Remove the selector mechanism.

Fig 5: Identifying Removal Of Selector Mechanism

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Installing 

Installation is performed in the reverse order of removal.

-- Install the heat shield under the selector mechanism.

-- Install the exhaust system. Refer to Description and Operation .

-- Adjust the selector lever cable after installing. Refer to SELECTOR LEVER CABLE, ADJUSTING .