Multifunction Transmission Range Switch -F125-: Removing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2009 Volkswagen Golf, 2008 Volkswagen Jetta, and 2008 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

-- Move the selector lever into the "N" position.

-- Turn off the ignition.

-- Disconnect the cable -arrows 1- and then remove it from the cable bracket -arrow 2-.

Fig 1: Identifying Cable Disengaged And Removed From Mounting Bracket

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Do not use pliers because the tabs on the cable bracket could break off.

Do not bend the selector lever cable.

-- Pry the cable -1- off the lever -3- using a open end wrench -2-.

Fig 2: Identifying Selector Lever Cable, Lever/Selector Shaft And 10mm Open-End Wrench

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connector from the multifunction transmission range switch.

-- Remove the nut -1-.

Fig 3: Identifying Selector Shaft Lever Components

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the spring washer -2- and the lever -3- from the selector shaft -4-.

-- Bend back the hooks on the lock washer -2- using a screwdriver.

Fig 4: Identifying Selector Shaft Components

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Replace the lock washer is a hook breaks off.

-- Remove the nut -1-.

-- Remove the bolts -5-.

-- Remove the multifunction switch -4- and the washers -2 and 3- from the selector shaft -6-.