ATF Level, Checking And Filling: Filling
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2009 Volkswagen Golf, 2008 Volkswagen Jetta, and 2008 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
-- Install and tighten the VAS 6262/2 to the inspection plug hole hand tight with the engine running.
-- Fill with 1 liter of ATF.
-- Tighten the VAS 6262 to the quick release coupling and check:
If the ATF flows out of the hole:
The ATF does not need to be topped off.
-- Allow the ATF to drain until it drips.
-- Install and tighten the inspection plug with a new seal to 27 Nm. The ATF level test is now completed.
If the ATF does not drip:
-- Fill with another liter.
WARNING:
Too little or too much ATF will impair the transmission. If 2 liters are missing, you should check the transmission more closely. There is probably a >>larger leak.<<