Slave Cylinder: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2008 Volkswagen Jetta, 2007 Volkswagen Jetta, and 2006 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal.

-- Install the clutch slave cylinder and tighten the bolts -arrows B- to specifications.

Fig 1: Identifying Transmission Support And Slave Cylinder

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Attach the hose/line assembly to the clutch slave cylinder.

-- Push the hose/line assembly clamp all the way in.

-- Pull on the hose/line assembly to make sure it is secure.

-- Install the transmission support and bolts -arrows A-.

-- Bleed the clutch system after installing the clutch slave cylinder. Refer to CLUTCH SYSTEM, BLEEDING .

Assemble the selector mechanism. Refer to SHIFT AND SELECTOR CABLES .

Adjust the shift mechanism. Refer to SHIFT MECHANISM, ADJUSTING .

-- If removed, install the air filter housing. Refer to one of the following:

Diesel engines, refer to [For engine(s) BRM] Description and Operation .

Gas engines, refer to [For engine(s) BGP, BGQ, CBTA, CBUA] Description and Operation .

-- Connect the ground cable to the battery. Refer to Removal and Installation .