Mounting Bracket: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2008 Volkswagen Jetta, 2007 Volkswagen Jetta, and 2006 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal.

Some vehicles have a damper -arrow- over the clutch pedal bracket.

Fig 1: Identifying Bracket With Sound Absorber

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Replace the self locking nuts.

Replace the hose clamps

Allocate all components

There are different ways of securing the impact bolster support -1- in front of the clutch pedal -2-.

Fig 2: Identifying Impact Bolster & Front Of Clutch Pedal

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Securing with Two Bolts

-- Install the impact bolster support -1- and tighten the 2 bolts to specification. Refer to TIGHTENING SPECIFICATIONS .

Securing with One Bolt

Fig 3: Identifying Impact Bolster & Bolt

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the impact bolster support -1- and tighten the bolt -2- to specification. Refer to TIGHTENING SPECIFICATIONS .

Continuation for All

-- Attach the wire guide -2- to the steering column.

Fig 4: Identifying Cable Ties, Cable Guide & Floor Vent

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the footwell vents -3-. Refer to Removal and Installation .

-- Install the trim and the cover under the trim on the driver side. Refer to Removal and Installation .

-- Press the hose/line assembly -1- or plastic line into the master cylinder connection -4- with a new seal -2- until the clip -3- engages audibly.

Fig 5: Identifying Hose/Line Assembly, O-Ring, Master Cylinder Connection & Securing Clip

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pull on the hose/line assembly or plastic line to make sure it is tight.

-- After removing the 3094 bring the return hose back to its original shape.

-- Bleed the clutch system. Refer to CLUTCH SYSTEM, BLEEDING .

-- Install the battery. Refer to Removal and Installation .

-- If removed, install the air filter housing. Refer to one of the following:

Diesel engines, refer to [For engine(s) BRM] Description and Operation .

Gas engines, refer to [For engine(s) BGP, BGQ, CBTA, CBUA] Description and Operation .