Master Cylinder: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2008 Volkswagen Jetta, 2007 Volkswagen Jetta, and 2006 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the bracket. Refer to MOUNTING BRACKET .

-- Unclip the mount for the master cylinder actuator rod using T10005.

Fig 1: Identifying Pliers T10005 To Disengage Master Cylinder Operating Rod Mount

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Place a spacer -A- between the clutch pedal and the jounce bumper and push the clutch pedal down as far as the spacer.

Fig 2: Identifying Method To Disengage Securing Bracket And Pull Master Cylinder Out Of Mounting Bracket

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Spacer size = approximately 40 mm (for example 1/2" drive socket)

-- Unlock the securing clip -B- and remove the master cylinder from the bracket -arrow 1- and -arrow 2-.