LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2009 >> GLI 2.0 J, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 171 (Clutches - 0A4 (Sedan) (A5 Platform)) >> 30 Clutch >> Removal And Installation >> Clutch Pedal >> Removing

Clutch Pedal: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2008 Volkswagen Jetta, 2007 Volkswagen Jetta, and 2006 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

-- Move the driver seat all the way back and raise the steering wheel to the highest position.

-- Remove the trim and the cover under the trim on the driver side. Refer to Removal and Installation .

-- Remove the wire guide -2- from the steering column.

Fig 1: Identifying Cable Ties, Cable Guide & Floor Vent
GWWN30-10001Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the footwell vents -3-. Refer to Removal and Installation .

There are different ways of securing the impact bolster support -1- in front of the clutch pedal -2-. The impact bolster support may look different than what is shown in the following illustrations.

Fig 2: Identifying Impact Bolster & Front Of Clutch Pedal
GWWN34-10315Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Securing with Two Bolts 

-- Remove the impact bolster support bolts and support -1-.

Securing with One Bolt 

Fig 3: Identifying Impact Bolster & Bolt
GWWN30-10117Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the impact bolster support bolt -2- and support -1-.

Continuation for All 

-- Remove the damper -arrow- from the clutch pedal bracket, if equipped.

Fig 4: Identifying Bracket With Sound Absorber
GWWN30-10195Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the retainers -A- for the damper.

Fig 5: Identifying Damper Retainers
GWWN30-10188Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the damper.

-- Push the damper near the upper nut -1- above the clutch pedal -A- in the -direction of the arrow-.

Fig 6: Locating Damper Near The Upper Nut
GWWN30-10189Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the nut -2- and bolt -5- and then remove the clutch pedal -1- from the bracket -3-.

Fig 7: Identifying Clutch Pedal, Mounting Bracket, Nut And Bolt
GWWA30-0125Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Swivel the clutch pedal slightly downward and remove the over center spring -4- from the bracket.

-- Unclip the clutch pedal from the master cylinder using T10005.

Fig 8: Identifying Pliers T10005 To Disengage Master Cylinder Operating Rod Mount
GWWA30-0118Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the clutch pedal.