Clutch Pedal Overview
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2008 Volkswagen Jetta, 2007 Volkswagen Jetta, and 2006 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
- Bulkhead
- With a mount for the bracket.
- Seal
- Always replace.
- Between the bracket and bulkhead.
- With self-adhesive.
- Attach to the bracket.
- Bracket
- For the clutch pedal mounting.
- Some equipment versions have a damper, refer to CLUTCH PEDAL OVERVIEW .
- Removing and installing, refer to MOUNTING BRACKET .
- Bolt
- Over Center Spring
- Removing and installing, refer to OVER CENTER SPRING .
- Bushing
- Pin
- Clutch Pedal
- Removing and installing, refer to CLUTCH PEDAL .
- Mount
- To remove and install, disconnect the master cylinder from the clutch pedal. Refer to CLUTCH PEDAL .
- Seal
- Always replace.
- Between the master cylinder and the bracket.
- Master Cylinder
- Remove and install after removing the bracket. Refer to MOUNTING BRACKET .
- Clutch Position Sensor -G476-
- Removing and installing, refer to CLUTCH POSITION SENSOR .
- Can be checked in "Guided Fault Finding" using the VAS 5051.
- The clutch position sensor is called the clutch pedal switch -F36-
- Clip
- The clip must be removed in order to remove/install the hose/line assembly.
- Supply Hose
- Rubber
- Made of plastic as of 12.05, refer to HYDRAULICS OVERVIEW .
- Nut, Self Locking
- 25 Nm
- Always replace.
- Quantity: 3
- For securing the bracket to the bulkhead.
- Nut
- 25 Nm
- Always replace.
- Jounce Bumper
- For the clutch pedal.