Clutch Release Mechanism Overview: Notes

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2008 Volkswagen Jetta, 2007 Volkswagen Jetta, and 2006 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required

Torque Wrench (5-50 Nm) V.A.G 1331
Grease for Clutch Splines G 000 100

Fig 1: Identifying Clutch Release Mechanism, Servicing Remove/Install Components

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Transmission
Ball Stud
- 25 Nm
- To remove and install, remove the transmission.
- Remove grease from the release lever contact surfaces.
- Lubricate using grease for clutch splines G 000 100.
Input Shaft Seal
- To remove and install, remove the transmission.
- Removing and installing, see -item 12- TRANSMISSION HOUSING AND CLUTCH HOUSING .
Guide Sleeve
- To remove and install, remove the transmission.
- With a vulcanized O-ring.
- Replace the guide sleeve and O-ring if the O-ring is damaged.
Spring
- To remove and install, remove the transmission.
- Attach to the clutch release lever.
Bolt
- 20 Nm
Clutch Release Lever
- To remove and install, remove the transmission.
- Remove and install together with the release bearing, refer to CLUTCH RELEASE MECHANISM OVERVIEW .
- Remove any grease already present.
Release Bearing
- To remove and install, remove the transmission.
- Do not wash the bearing, just wipe it off.
- Replace loud bearings.
- Removing from, and installing to the clutch release lever, refer to CLUTCH RELEASE MECHANISM OVERVIEW .
- Lubricate the release lever contact surfaces with MoS ₂ grease.
Bolt
- 20 Nm
Clutch Slave Cylinder
- Removing and installing, refer to SLAVE CYLINDER .
Plunger
Assembly Bolt
- Secures the clutch release lever when installing the transmission.
- Remove after installing the transmission.
  NOTE:
  Use an M6 x 35 bolt if the assembly bolt -item 12- is missing.