Clutch Overview, SACHS
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2008 Volkswagen Jetta, 2007 Volkswagen Jetta, and 2006 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
- Dual Mass Flywheel
- Removing and installing, refer to one of the following:
Diesel engines, refer to [For engine(s) BRM] Removal and Installation .
Gas engines, refer to [For engine(s) BGP, BGQ, CBTA, CBUA] Removal and Installation .
- Make sure it fits securely on the alignment pins.
- Keep the clutch lining contact surface free of grooves, oil and grease.
- Removing and installing, refer to one of the following:
- Clutch Plate
- Removing and installing, refer to CLUTCH, SACHS .
- Only replace together with the pressure plate.
- Installed position, refer to CLUTCH, SACHS .
- Pressure Plate
- With a adjustment mechanism.
- Removing and installing, refer to CLUTCH, SACHS .
- Check the ends of the diaphragm spring, refer to CLUTCH, SACHS .
- Checking the spring and rivet connections, refer to CLUTCH, SACHS .
- Only replace together with the clutch plate.
- Bolt
- M6 = 13 Nm
- M7 = 20 Nm
- Loosen and tighten in small steps and in a diagonal sequence.