New Connecting Rod Separating

New connecting rods may not be separated at the location where they should be. If the connecting rod bearing cap cannot be removed by hand, proceed as follows:

-- Mark which cylinder the connecting rod. Connecting Rod (List Item: 11) belongs to.

-- Lightly clamp the connecting rod in a vise equipped with aluminum jaw pads.

Fig 1: Identifying Connecting Rod Clamped In Vise Equipped With Aluminum Protective Pads

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Only clamp the connecting rod lightly to avoid damaging it.

Clamp the connecting rod below the dotted line.

-- Loosen both bolts -arrows- about 5 turns.

-- Carefully tap against the connecting rod bearing cap in the -direction of the arrow- with a plastic mallet until the cap is loose.

Fig 2: Identifying Direction To Carefully Tap Against Connecting Rod Bearing Cap

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.