Oil Separator

Special tools and workshop equipment required 

• Torque Wrench (5-50 Nm) V.A.G 1331

Removing 

-- Remove the noise insulation. Refer to Description and Operation .

-- Remove the bolts -9 through 1- and remove the oil separator.

Fig 1: Identifying Oil Separator Tightening Sequence

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Installing 

Install in reverse order of removal. When doing this note the following:

-- Tighten the bolts in sequence -1 through 9-.

Fig 2: Identifying Oil Separator Tightening Sequence

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Tightening specification: 9 Nm