Rear Lid Overview
- Hinge Cover
- Wiring Harness
- Rear Lid
- Removing and installing, refer to REAR LID .
- Adjusting, refer to REAR LID, ADJUSTING .
- Rear Lid Trim
- Removing and installing, refer to Removal and Installation .
- Adjusting Buffer
- Left and right
- To install, rotate 90° toward left -arrow-.
- Adjusting, refer to ADJUSTMENT BUFFER, ADJUSTING .
- Hex Nut
- 22 Nm
- Quantity: 2
- Rear Lid Hinge
- Removing and installing, refer to REAR LID HINGE .
- Rubber Buffer
- Bolt
- 22 Nm
- Quantity: 3
- Gas Strut
- Removing, refer to GAS STRUT .
- Releasing the gas, refer to VENTING GAS-FILLED STRUT .
- Bolt
- 23 Nm
- Quantity: 2
- Striker
- Removing and installing, refer to STRIKER .
- Internally Threaded Pop Rivet
- Identification Plate
- Different versions