Instrument Cluster, Through Model Year 2009

Before removing the instrument cluster, perform the INSTRUMENT CLUSTER, REPLACEMENT procedure to read out the data saved in the Instrument Cluster Control Module -J285-.

CAUTION:

Turn off the ignition and all electrical consumers.
Remove the key.

Removal

NOTE:

It is not necessary to remove the steering wheel.

-- Pull the steering wheel all the way out and then lower as far down as it will go.

-- Remove the upper section of the steering column trim. Refer to Removal and Installation .

-- Remove the bolts -arrows-.

Fig 1: Identifying Instrument Cluster Mounting Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

The fixed electrical connection to the instrument cluster is disconnected automatically when the cluster is pulled out of the instrument panel opening. Harness connector is installed permanently in vehicle and is disconnected automatically when pulling out instrument cluster.

-- Pull the instrument cluster back out of the instrument panel while being careful of the connected wires.

Installation

Install in reverse order of removal. Note the following:

-- Tighten the threaded connection to 1.5 Nm.