Instrument Cluster, Replacement

Special tools and workshop equipment required 

• Vehicle Diagnostic Tester

Work procedure "replace instrument cluster" contains the following scope of work:

• If a new instrument cluster is installed in the vehicle, the Instrument Cluster Control Module -J285- must be adjusted to the various equipment characteristics and corresponding version for that country.
• To adapt the integrated Anti-theft immobilize control module -J362- with the Engine Control Module -J623- (ECM), it is necessary to save the data from the engine control module in the replacement instrument cluster.
• Also, all ignition keys must be adapted after installation of a new instrument cluster.

Procedure 

-- Connect the Vehicle diagnostic tester.

-- Select Guided Fault Finding  .

-- Use the GO TO  button to select the "function/component selection" and the following menu options one after the other:

• Body
• Electrical Equipment
• 01 - On Board Diagnostic (OBD) capable systems
• Instrument Cluster
• Instrument cluster functions
• Instrument cluster, adaptation/replacing