Accelerator Pedal Module

WARNING: This page is about a different car, the 2009 Volkswagen Rabbit, 2008 Volkswagen Rabbit, 2007 Volkswagen Rabbit, and 2006 Volkswagen Rabbit. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Release Tool T10238

Procedure

-- Remove the drivers side foot well cover.

-- Disconnect the connector from the accelerator pedal module.

-- Remove the cap on top of the accelerator pedal module.

-- Remove the bolt.

-- Push the release tool T10238 all the way into the opening as illustrated.

Fig 1: Installing Release Tool T10238

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the accelerator pedal module vertically.

Install in reverse order of removal.