Seal, Transmission Side

Special tools and workshop equipment required 

• Assembly Tool T10122
• Pulling Hook T20143

Removing 

-- Remove the transmission. Refer to one of the following:

Manual: [For transmission(s) 0A4] Removing .

Automatic: [For transmission(s) 09G] Removing .

-- Lock the crankshaft. Refer to CRANKSHAFT, LOCKING .

-- Remove the flywheel or drive plate and remove the sensor wheel for the engine speed sensor -G28- from the crankshaft.

-- Pull out the seal using the pulling hook T20143/2.

Fig 1: Pulling Out Sealing Ring Using Pulling Hook T20143/2

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Be careful not to damage the sealing surface on the crankshaft.

Installing 

-- Clean the sealing surfaces. They must be free of oil and grease.

-- Before installing, remove any remaining oil from the crankshaft journal with a clean cloth.

-- Insert the assembly device T10122/1 onto the pull sleeve T10122/2 and slide the seal -A- onto the pull sleeve.

Fig 2: Identifying Seal, Sleeve T10122/1 And Assembly Tool T10122/2

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the assembly device T10122/1.

-- Install the pull sleeve T10122/2 with the seal -A- onto the crankshaft.

Fig 3: Installing Pull Sleeve T10122/2 With Sealing Ring Onto Crankshaft

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press in the seal all around evenly and flush using the pressure sleeve T10122/3.

The rest of the installation follows the reverse of the removal procedure. Note the following:

• Remove the locking pin T40069 from the cylinder block and install the plug.

Tightening Specifications