LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2008 >> R32 >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Gears, Shafts - 5-Speed Manual Transmission 0A4 (As Of 04.2010)) >> 35 Gears, Shafts >> Disassembly And Assembly >> Output Shaft >> Checking 1st Gear and 2nd Gear synchronizing Ring for Wear

Checking 1st Gear and 2nd Gear synchronizing Ring for Wear

WARNING: This page is about a different car, the 2009 Volkswagen Rabbit, 2008 Volkswagen Rabbit, 2007 Volkswagen Rabbit, and 2006 Volkswagen Rabbit. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Checking 1St, 2Nd And 3Rd Gear Synchro-Rings For Wear
GWWV35-1137Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the synchronizer ring, outer race and inner race onto taper of selector gear and then measure the gap dimension -a- with a feeler gauge.

Gap Dimension -a- Installed Dimension Wear Limit
1st and 2nd gear 1.2 to 1.8 mm 0.5 mm
scientia non olet · About LEMON Manuals