Assembly: Locking Collar/Synchronizer Hub for 1st and 2nd Gears together with Locking Pieces that are Hollow on the Inside
WARNING: This page is about a different car, the 2009 Volkswagen Rabbit, 2008 Volkswagen Rabbit, 2007 Volkswagen Rabbit, and 2006 Volkswagen Rabbit. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Assembling Locking Collar/Synchronizer Hub Of 1st And 2nd Gear In Conjunction With Hollow Locking Pieces
- The locking collar is pushed over the synchronizer hub.
-- Install the locking pieces and springs offset by 120°. The angled end of the spring must engage into the hollow locking piece.