Clutch, LUK: Notes

WARNING: This page is about a different car, the 2009 Volkswagen Rabbit, 2008 Volkswagen Rabbit, 2007 Volkswagen Rabbit, and 2006 Volkswagen Rabbit. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Flywheel Retainer 3067
Centering Mandrel 3190 A
Torque Wrench (5-50 Nm) V.A.G 1331
Grease for Clutch Splines G 000 100

Removing

-- Remove the transmission.

-- Using 3067, loosen the clutch bolts.

-- Loosen the bolt diagonally and in small steps.

-- Remove the pressure plate and the clutch plate.

Installing

Install in reverse order of removal.

NOTE:

Replace the pressure plate and the clutch plate together. Allocate the pressure plate and the clutch plate according to the engine code.

Make sure the alignment pins for centering the engine/transmission are installed inside the cylinder block. Install them if necessary.

If the alignment pins are missing, it will be difficult to shift, there will be clutch problems and transmission may make noises (loose rattling).