Wheel bearing, pressing out

Fig 1: Removing Wheel Bearing Circlip

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove circlip - 1  -.

Fig 2: Piston Cylinder Installed With Pull Rod And Special Tool

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Position thrust piece - 1  - on back of wheel bearing.
• Install piston cylinder - 2  - with pull rod - 3  - and special tool - 4  -.

1 - Press piece E-5

2 - Piston cylinder HKZ-15

3 - Removal rods E-0-217

4 - Special nut E-8-214

5 - Bell E-44

• Build-up pressure with foot pump.
• Now check that all tools are correctly centered.
• Press out the wheel bearing by operating the pump.

Fig 3: Pull Bearing Inner Race Off From Wheel Hub

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Pull bearing inner race off from wheel hub.