Service Interval Display, Resetting

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2009 Volkswagen GLI, 2008 Volkswagen Jetta, and 2008 Volkswagen GLI. However, it is still accessible from the selected car via links, so may be relevant.

Service interval display must be reset at

Vehicle release inspection
Every service

(adapted)!

-- Connect the diagnostic tester. Refer to VEHICLE TESTER, CONNECTING .

-- Switch the ignition on.

-- Touch button/field on screen: GUIDED FUNCTIONS .

If the displays indicated in the procedure are not shown on the display. Refer to Operating instructions for Vehicle Diagnosis, Testing and Information System 5051 or Vehicle Diagnosis & Service Syst. VAS 5052.

-- Press the > button to confirm.

-- Select in succession:

Brand
Type
Model year
Engine Code

-- Confirm vehicle identification.

-- Select in succession:

"Instrument cluster" -arrow-.

Fig 1: Identifying "Instrument Cluster" Selection On Scan Tool
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
"Rest service interval display".

-- Perform Adaptation according to instructions from "GUIDED FUNCTIONS".

Fig 2: Identifying "Go To" Button On Scan Tool Display

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

End Adaptation

Indicated on display:

-- Press the Go to button -arrow- on display.

Indicated on display:

Fig 3: Identifying "Exit" Button On Scan Tool Display

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press End button -arrow- on display.

-- Press Exit button in exit menu.

-- Turn off ignition and disconnect diagnostic connection.

-- Switch the ignition on.

After switching on the ignition, service event is no longer indicated in the odometer display in the instrument panel insert.