Service Interval Display, RECODING At First Oil Change Service

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2009 Volkswagen GLI, 2008 Volkswagen Jetta, and 2008 Volkswagen GLI. However, it is still accessible from the selected car via links, so may be relevant.

-- Connect the diagnostic tester. Refer to VEHICLE TESTER, CONNECTING .

-- Switch the ignition on.

-- Touch button/field on screen: ON BOARD DIAGNOSTICS (OBD) .

NOTE:

If the displays indicated in the procedure are not shown on the display. Refer to Operating instructions for VAS 5051 or VAS 5052

-- Select in succession:

Brand
Type
Model year
Engine Code

-- Confirm vehicle identification.

If vehicle identification was performed correctly, then press the > button to confirm.

-- Select in succession:

17 "Instrument cluster" -arrow-.

Fig 1: Identifying "Instrument Cluster" Selection On Scan Tool
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
10 "Adaptation"

-- Select channel 49.

-- Enter 372.

-- Select channel 42.

-- Perform adaptation according to instructions of "ON BOARD DIAGNOSTICS (OBD)".

NOTE:

For vehicles in USA and Canadian markets, the following applies:

Channel 42: 100 (= 10, 000 miles) for USA

Channel 42: 160 (= 16, 000 km) for CDN

Channel 49: 372 (= 372 days) for USA and CDN

End Adaptation

Indicated on display:

Fig 2: Identifying "Go To" Button On Scan Tool Display

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press the Go to button -arrow- on display.

Indicated on display:

Fig 3: Identifying "Exit" Button On Scan Tool Display

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press Exit button -arrow- on display.

-- Turn off ignition and disconnect diagnostic connection.