Service Interval Display, RECODING At Delivery Inspection

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2009 Volkswagen GLI, 2008 Volkswagen Jetta, and 2008 Volkswagen GLI. However, it is still accessible from the selected car via links, so may be relevant.

-- Connect the diagnostic tester. Refer to VEHICLE TESTER, CONNECTING .

-- Switch the ignition on.

-- Touch button/field on screen: GUIDED FAULT FINDING .

NOTE:

If the displays indicated in the procedure are not shown on the display. Refer to Operating instructions for VAS 5051 or VAS 5052

-- Select in succession:

Brand
Type
Model year
Engine Code

-- Confirm vehicle identification.

If vehicle identification was performed correctly, then press the > button to confirm.

-- Select in succession:

Body
Electrical Equipment
01 - On Board Diagnostic (OBD) capable systems
"Instrument cluster" -ARROW-.

Fig 1: Identifying "Instrument Cluster" Selection On Scan Tool
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
Instrument cluster functions
"Adapt Service Interval Display".

NOTE:

Check which intervals are set.

Intervals must be set or recoded for first oil change service at 5, 000 miles/8, 000 km.

-- Perform Adaptation according to instructions from "GUIDED FAULT FINDING".

Vehicles from MY 2007:

NOTE:

For vehicles in USA and Canadian markets, the following applies:

Channel 50: 50 (= 5, 000 miles) for USA

Channel 50: 80 (= 8000 km) for CDN

Channel 51: 372 (= 372 days) for USA and CDN

When coding to QG0 or QG2: Channels 42 + 49 are not available and are replaced with channels 50 + 51.

Furthermore, when coding QG0, QG2, channels 43, 44 and 49 are deactivated

End Adaptation

Indicated on display:

Fig 2: Identifying "Go To" Button On Scan Tool Display

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press the Go to button -arrow- on display.

Indicated on display:

Fig 3: Identifying "Exit" Button On Scan Tool Display

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press Exit button -arrow- on display.

-- Turn off ignition and disconnect diagnostic connection.